![]() ![]() During and after drilling, use a vacuum cleaner to remove dust and waste, and clean up any splashes of water that may have been created while drilling. This will help to reduce any heat generated from drilling, which can cause cracking on the surface of the stucco. When drilling, slowly and gradually increase the speed. Make sure to wear safety glasses and hearing protection, as the noise and dust created by drilling can be dangerous. You will need to use a heavy-duty drill and an SDS cement bit or a masonry bit (hammer drill) to ensure a clean hole. How do you drill into concrete stucco?ĭrilling into concrete stucco involves a bit of caution and safety equipment. For these reasons, it is not recommended that you drill through stucco, as it is not an effective, or safe, way to achieve what you want to do. On top of that, the mixture of lime and water makes the material softer and more susceptible to breakage.Įven if you were to try and use a drill, the noise and vibration caused by the drill itself could easily damage the stucco. In most cases, this makes it impossible to drill through without cracking or crumbling the aggregate. This is because stucco is made up of an aggregate of materials, such as sand and gravel, held together with a mixture of lime, water and cement. Why can’t I drill through stucco?Īlthough stucco is a relatively sturdy material, it’s not a very good candidate for drilling. ![]() This will ensure the stability and longevity of whatever you are attaching to the stucco. Once the hole is drilled and the screw is inserted, you can use a Phillips-head screwdriver to counter-sink the screw into the hole. Start by pre-drilling a hole into the stucco with the masonry drill bit, as this will make a much easier and more secure “mate” for the screw. Be sure to use a masonry drill bit of the appropriate size – one-eighth to one-quarter inch should suffice. First, you will need to determine what type of screws will be the most appropriate for the job.įor attaching items such as wall plugs and other hardware to stucco, the best choice is a one-quarter inch self-tapping lag screw. When screwing something into stucco, it is important to use the right kind of screws and tools, as well as a masonry drill bit. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |